ADDONICS TECHNOLOGIES
Model: ADIDEU2
Installation Guide
Front View
3. Using the provided Y-power cable, connect the 4-pin
4-Pin Floppy
Power Connector
floppy connector to the power connector of the
converter. This will provide power to the converter.
B-Type USB
Connector
USB Pin
Header
4. At the other end of the Y-power cable is the 4-pin Molex
power connector that you connect to the hard drive.
Back View
IDE Connector
Note:
It is required to set up the IDE hard drive you are
connecting to the converter as a MASTER device.
5. Now connect the B-type USB cable to the USB port on
the converter or use the USB pin header cable.
1. Locate the 40-pin IDE connector of your IDE drive.
4-pin Molex
Power Connector
B-Type USB cable
USB Pin Header
cable
40-pin IDE Connector
Master or Slave
Jumper Settings
2. Connect the converter board to the IDE connector of the
hard drive.
TECHNICAL SUPPORT
Email:
Internet:
Technical Support (8:30 am to 6:00 pm PST)
Phone:
Email:
408 433-3855
|
HP Hewlett Packard AMD Geode ECM 5510 User Manual
Honeywell HomeBase D7900 User Manual
Hobart HGC5X User Manual
GE Monogram ZGW125 User Manual
GE General Electric Cooktop PP942 User Manual
Freescale Semiconductor Computer Hardware S08 User Manual
EVGA 132 LF E655 KR User Manual
Cortelco Caller ID Type II 9125 User Manual
Black Box Computer Hardware LPS500A SM 10K SC User Manual
A T International CL83101 User Manual