Ativa Portable Speaker PF112 User Manual

To Power on the unit: Press On/Off button on Top Panel of the unit  
To adjust the Volume: Press Volume Control button on the Top Panel of unit  
To turn on the Bass Booster Effect: Press the Bass button on the Top Panel of the unit  
To Power off the unit: Press On/Off button again  
Model: PF112  
Too much distortion  
Battery Life  
Batteries are low, Replace batteries  
Clean the battery contacts and those of the devices prior to the battery installation.  
Please remove the Batteries from the compartment, when it is not in use  
Please Power Off the unit, when it is not in use  
PF112 Portable Speaker for iPod User Manual  
Power Green LED indicator (on the Speaker):  
• LED Off – Power OFF  
Do not use old and new batteries together  
Box Contents:  
• LED ON – Power ON  
• PF112 Portable Speaker for iPod  
• Docking cradles for iPod Models  
• AC Adaptor  
• Audio Cable  
• User Manual  
Caution:  
Specification:  
Modifications not approved by the party responsible for compliance could void user’s authority to operate the equipment.  
Total 5W output (2.5W / Channel)  
• Mid range (70mm x 30mm) Elliptical driver / Channel  
• Distortion <= 10 % @ 3W  
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-  
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may  
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of the following measures:  
• S/N ratio:>65dB@1W  
General Speaker setup:  
• Select the correct iPod Cradle and insert into the iPod docking area  
• Insert your iPod into the docking or plug the Stereo Line-in cable at the back of the product  
• Connect the supplied Power Adaptor to the Power Outlet and PF112 Speaker; or insert 4 pcs of AA battery at the bottom of Speaker.  
• Remark: the Line-in Signal will be higher priority than the iPod Signal. Make sure the Line-in cable is unplugged, when going to  
enjoy the music from iPod.  
• Frequency Response: 200Hz – 16kHz  
• Provided Power Adaptor: 5VDC @ 2A  
• Dimension: 9.25 in x 4.33 in x 2.11 in (235 mm x 110 mm x 53.5 mm)  
• Reorient or relocate the receiving antenna.  
Compatibility (iPod)  
• iPod 1st touch  
• iPod 2nd touch  
• iPod Classic(80G Version only)  
• iPod 4th nano  
• iPod 3rd nano  
• Increase the separation between the equipment and the receiver.  
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
Operation Instruction:  
Power LCD  
Indicator  
Volume Volume  
Down Up  
Bass  
Power  
• iPod 2rd nano  
Trouble Shooting:  
Sound not Clear or no sound  
LED No Power  
Please check the Cable or iPod connection  
Please check the Power Cable connection  
Please check the Battery Power  
Press the Power On/Off button again  
Sound is too Low/ too much  
distortion  
Press volume button to adjust  
Adjust the volume of attached music device  
 

Abocom Switch SW500B User Manual
Accusplit Heart Rate Monitor AX740 User Manual
AEG Range 3007VNM M User Manual
Agri Fab Spreader 175 User Manual
Alliance Laundry Systems Washer LTS80A User Manual
Alphasonik Speaker PSW410E User Manual
Audiovox Automobile Alarm APS 15CH User Manual
Audiovox Automobile Alarm IMO 720 User Manual
Behringer Music Mixer EURODESK User Manual
Behringer Music Pedal US600 User Manual